污水處理設備 污泥處理設備 水處理過濾器 軟化水設備/除鹽設備 純凈水設備 消毒設備|加藥設備 供水/儲水/集水/排水/輔助 水處理膜 過濾器濾芯 水處理濾料 水處理劑 水處理填料 其它水處理設備
廊坊伊爾可過濾器材有限公司
廊坊伊爾可過濾器材有限公司
閱讀：1306發布時間：2020-7-5
一、簡介
本過濾器安裝在油泵吸油口處，用以保護油泵及其他液壓元件，以避免吸入污染雜質，有效地控制液壓系統污染，提高液壓系統的清潔度。
本過濾器可直接安裝在油箱側邊，上部或底部，吸油筒體侵入油箱內液面以下，過慮器濾頭露在油箱外，并設有自封閥，旁通閥，濾芯污染堵塞發訊器等裝置，使更換濾芯和清洗濾芯時油箱內油液不會流出，本產品設計新穎，安裝方便，通油能力大，阻力小，清洗或更換濾芯方便等優點。
二，性能與特點
1.安裝連接方便，簡化系統管路：
本過濾器可直接安裝在油箱側邊，上部或底部，過慮器濾頭露在油箱外，吸油筒體侵入油箱內液面以下，出油口設有管式，法蘭式連接，過濾器內設置自封閥等裝置，使管路省去裝截止閥等其它管件，從而使管路簡化，安裝方便。
2.設置自封閥，使更換，清洗濾芯或維修系統非常方便：
當更換、清洗濾芯或維修系統時，只需旋開過濾器端蓋（清洗蓋），此時自封閥會自動關閉，隔絕油箱油路，使油箱內油液不會向外流出，從而使清洗，清洗濾芯或維修系統非常方便，如頂開自封閥又可作油箱向外放油之用。
3.具有濾芯污染發訊器與油路旁通閥，提高了以液壓系統的可靠性：
當濾芯被污染物塞到出油口真空度為0.018Mpa時，發訊器便會發出訊號，應及時更換或清洗濾芯。若此時不能馬上停機或無人來更換濾芯時，在濾芯上部的油路旁通閥會自動開啟（開啟值為：真空0.02Mpa），以避免油泵出現吸空故障。但此時應停機更換或清洗濾芯，以保持液壓系統的清潔度，提高液壓系統的可靠性。
廊坊伊爾可過濾器材有限公司
1、 Introduction
The filter is installed at the oil suction port of the oil pump to protect the oil pump and other hydraulic components, avoid the inhalation of pollution impurities, effectively control the pollution of the hydraulic system, and improve the cleanliness of the hydraulic system.
The filter can be directly installed on the side, top or bottom of the oil tank. The oil absorption cylinder invades below the liquid level in the oil tank. The filter head of the filter is exposed outside the oil tank, and is equipped with self sealing valve, bypass valve, filter element pollution blocking transmitter and other devices, so that the oil in the oil tank will not flow out when replacing the filter element and cleaning the filter element Or it is convenient to replace the filter element.
2、 Performance and characteristics
1. Convenient installation and connection, simplified system pipeline:
The filter can be directly installed on the side, top or bottom of the oil tank. The filter head of the filter is exposed outside the oil tank, and the oil absorption cylinder invades below the liquid level in the oil tank. The oil outlet is equipped with pipe and flange connection, and the filter is equipped with self sealing valve and other devices, so that the pipeline can be simplified and installed conveniently.
2. The self sealing valve is set to make it convenient to replace, clean the filter element or maintain the system
When replacing or cleaning the filter element or maintaining the system, just loosen the end cover (cleaning cover) of the filter. At this time, the self sealing valve will automatically close to isolate the oil circuit of the oil tank, so that the oil in the oil tank will not flow out. Therefore, it is very convenient to clean and clean the filter element or maintain the system. If the self sealing valve is opened, it can also be used to drain oil from the oil tank.
3. It has filter element pollution transmitter and oil bypass valve, which improves the reliability of hydraulic system
When the filter element is blocked by pollutants to the oil outlet, and the vacuum degree is 0.018mpa, the transmitter will send a signal, and the filter element should be replaced or cleaned in time. If the unit can not be shut down immediately or there is no one to replace the filter element, the oil way bypass valve on the upper part of the filter element will open automatically (opening value: vacuum 0.02MPa), so as to avoid the oil pump suction failure. But at this time, the filter element should be replaced or cleaned to keep the cleanliness of the hydraulic system and improve the reliability of the hydraulic system.
環保在線 設計制作，未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼